SeaLand 4 User Manual download pdf (Page 2)

The model identication label is located on the toilet base

and will show the model number and serial number. Follow

instructions for removing toilet pedestal cover in “Pedestal

and Pedal Cover Installation” on page 3. If label is not

available, please refer to “Dimensional Specications” on

page 4 for toilet model identication.

TOILET MODEL IDENTIFICATION

1. Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, in the system. These

products damage the seals in toilets and dump valves.

2. Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc.) to be ushed through

the toilet.

3. Mechanical seal toilets, like SeaLand Traveler units, are designed to only discharge directly into a holding

tank. Horizontal pipe runs as found in conventional residential or commercial plumbing systems cannot be

accommodated.

4. Toilet must be regularly cleaned and winterized according to “Proper Bowl Cleaning” and

“Winterizing” procedures on page 4, or your warranty coverage may be voided.

IMPORTANT INFORMATION

TABLE OF CONTENTS

To prepare the Traveler toilet for use, make sure water supply to the toilet

is connected. Turn on water supply and check system for leaks. Flush toilet

and check again for leaks.

Make sure the ushing instruction label (shown at right) is in plain sight and easy for

guests to read. If this label is not included in this manual, please contact the

SeaLand Product Customer Service Department immediately.

To properly use the Traveler toilet, follow these simple instructions:

1. To add water to the toilet, lift or raise the ush lever until desired

water level is reached. Generally, more water is required only when

ushing solids.

2. To ush toilet, push lever all the way down until contents leave toilet

bowl. Water ow pressures vary at

different locations, therefore holding the ush lever down for 4-8 seconds may be required. We require a

minimum ow at the inlet of the toilet of 2 gpm (7.6 lpm) for proper ushing.

3. Allow ush lever to snap back, which permits positive sealing around the ush ball.

4. A small amount of water should remain in bowl.

Note: Holding ush lever down longer than necessary results in excessive water usage.

HOW TO USE

Important Information ............................................. 2

Toilet Model Identication ...................................... 2

How to Use ............................................................. 2

Installation .............................................................. 3

Pedestal and Pedal Cover Installation .................. 3

Proper Bowl Cleaning ............................................ 4

Winterizing ............................................................. 4

Dimensional Specications..................................... 4

Deodorants and Special Tissue ............................. 5

Service Tip ............................................................. 5

Troubleshooting Guide ......................................6 - 7

Ordering Parts ........................................................ 8

Customer Service ................................................... 8

Manufacturer’s Limited Warranties ........................ 8

DOMETIC CORPORATION

P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886

BIG PRAIRIE, OH 44611 USA

MODEL NO. 000

SERIAL NUMBER

000000

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

SeaLand 4 User Manual Page 2

Comments to this Manuals

Related products and manuals for TVs & monitors SeaLand 4